The Samsung Galaxy S24 Ultra Blue rear glass is an original manufacturer part, supplied in Service Pack. It comes directly from Samsung production lines, without intermediaries, and bears the manufacturer reference GH82-33349F. This official packaging guarantees component traceability, quality control according to Samsung specifications, and strict compliance with original standards. The Blue colour corresponds to the Galaxy S24 Ultra S928B model.

Service Pack: what the packaging provides

A Service Pack is a new part packaged by Samsung for its authorised repair channels. Nothing has been refurbished, no glass has been replaced: the component comes from the same production lines as those fitted at the factory during initial assembly. What distinguishes it from a part in standard packaging is the packaging itself, designed for workshop replacement, with official markings, security seals and a unique identification code. This format ensures complete traceability and immediate recognition by Samsung service centres.

When to replace the rear glass

A cracked rear glass immediately exposes internal components: dust, moisture and impacts reach the battery, motherboard and flex cables. Even a fine crack compromises the IP68 water resistance of the Galaxy S24 Ultra, and an impact on the camera area can misalign the optics without breaking them. Glass replacement is justified from the first visible crack, before it spreads or foreign matter damages the underlying electronics. A chip on the edge of the titanium frame facilitates liquid ingress during accidental exposure.

What the 2-year warranty covers

This rear glass benefits from a 2-year warranty against any manufacturing defect: faulty adhesive, glass not compliant with original specifications, missing or altered manufacturer markings. The warranty covers part replacement in the event of a confirmed defect; it does not extend to damage caused by a drop, impact, improper handling during installation or repair carried out by an unqualified third party. A minor cosmetic defect with no impact on component function is not covered by the warranty.

Precautions for removal and installation

Removing the old glass requires gradual heating of the perimeter adhesive with a heat gun, between 80 and 100 °C, to avoid overheating the battery located directly beneath the back panel. A soft plastic pick slid between the chassis and the glass allows it to be removed without forcing on the titanium frame or damaging the wireless charging coils bonded to the back of the glass. Adhesive residue is removed with isopropyl alcohol before installing the new component. The Service Pack glass is attached using the pre-installed adhesive: precise alignment of the camera and sensor cut-outs, uniform pressure around the entire perimeter, then clamping for 24 hours under weight distributes the adhesive and ensures water resistance.