Double-sided adhesive for Samsung Galaxy Xcover 7, formulated identically to the one used in the factory by Samsung during assembly of new devices. This Service Pack adhesive ensures immediate and lasting fixation of the screen to the chassis, with no residue after removal and no risk of air bubbles. Supplied ready to apply, it eliminates failures linked to standard adhesives and guarantees the same performance as during the initial manufacturing of your device.

Original manufacturer part tested before shipment, it restores factory assembly quality in a single application. Compatible exclusively with the Galaxy Xcover 7, it carries manufacturer traceability and official Samsung markings. 2-year warranty.

Why replace the screen adhesive on the Galaxy Xcover 6 Pro

The double-sided adhesive that secures the screen to the chassis of the Galaxy Xcover 6 Pro gradually wears down over time and through impacts. When the glass begins to lift at the corners or slightly separates from the frame, it is this adhesive film that has lost its effectiveness. Air bubbles appearing under the screen, or conversely a fixture that becomes loose, signal that it needs to be replaced. Weakened adhesive allows moisture to seep between the glass and the display, which quickly damages the touch sensors and the display.

This adhesive is original Samsung manufacturer and reproduces exactly the composition and thickness of the one used in the factory. It offers immediate adhesion without residue, which means it secures the glass in seconds and leaves no sticky traces if the part needs to be removed later. It is this reliability that distinguishes original adhesive from cheap solutions, which swell or soften after a few months.

Service Pack: what this packaging means

The adhesive arrives in Service Pack, that is, in the official Samsung packaging intended for repair workshops. This designation guarantees that the part comes directly from Samsung production lines, without intermediate processing. It bears the manufacturer reference GH02-24129A, which allows the repairer to verify that it is indeed the correct adhesive before installing the part.

Delivered in Service Pack, this part benefits from the same quality control as that applied to each new phone assembled by Samsung. It ensures permanent fixation of the screen, with no risk of air bubbles or early lifting. The manufacturer warranty covers 2 years this part against manufacturing defects, which protects your repair investment.

Composition and installation of the adhesive

This double-sided adhesive comes as a thin, transparent film, pre-cut to the exact dimensions of the Galaxy Xcover 6 Pro screen. You do not need to cut or adapt anything: it is applied directly to the chassis or to the glass, depending on the repairer's technique. Adhesion occurs in seconds and requires no drying time. Unlike liquid adhesives or generic tapes, this film does not attract dust and does not create weak areas where the screen could lift again.

Installation requires cleanliness: surfaces must be thoroughly cleaned and dried before application, with no traces of old adhesive or dust. A screen poorly cleaned before application risks not adhering properly, which would cancel out the advantage of this original part. This is why professionals always verify that the chassis and glass are free of contaminants before applying the adhesive.

Exact compatibility with the Galaxy Xcover 6 Pro

This adhesive is designed specifically for the Galaxy Xcover 6 Pro (model reference F736B). It does not fit other Samsung models, which use different adhesive dimensions or formulations. Before ordering, verify that you own the Xcover 6 Pro by checking the model number on your device or your old part.