Samsung Galaxy S26 Back Glass Adhesive (Original)
Rear glass adhesive for Samsung Galaxy S26, intended to refix the rear glass after a replacement or disassembly. This is a refurbished original part: the component comes from an original device, cleaned then inspected before being put back into circulation. This adhesive kit ensures a clean fit and good hold of the rear glass on the chassis. Part checked before shipping. 2-year warranty.
Why replace the back glass adhesive on the Galaxy S26?
The back glass of the Samsung Galaxy S26 is bonded to the chassis with a single-use adhesive. Once removed, whether to change the battery, repair a charging connector or replace the glass itself, this adhesive loses its bonding power: it cannot be reused. Refitting it without replacement exposes the device to dust and moisture ingress, and the glass risks coming loose again after a few weeks.
This adhesive is an exact replacement for the original layer, with the same cutout and the same sealing areas as those specified by the manufacturer for this model.
A reconditioned original part
This adhesive is a reconditioned original part: it comes from an authentic device, from which it was extracted, cleaned and then inspected before being put back into circulation. It is neither a copy made by a third party, nor a new adhesive in manufacturer packaging, but a component genuinely taken from a Galaxy S26.
This choice makes it possible to offer a part true to the original dimensions and thickness, at a lower cost than a new part, which matters particularly for a consumable such as an adhesive.
Does this adhesive fit my Galaxy S26?
This reference is intended for the Samsung Galaxy S26 exclusively. It matches the back glass cutout of this model and does not fit another chassis, even one that looks visually similar.
Before ordering, check on your device that it is indeed the Galaxy S26: as the adhesive is cut to the millimetre for this specific model, a wrong choice of listing becomes apparent as soon as fitting begins.
What warranty applies to this adhesive?
The part is covered by a 2-year warranty. In the event of a defect found on receipt or after fitting, this warranty applies under the shop's usual terms.
Fitting a new adhesive: points to observe
Removing the old adhesive requires patience: the glass must be gently heated to soften the residual adhesive without exceeding the temperature that would damage the screen or the internal components located nearby. The chassis must then be cleaned of all residue before positioning the new adhesive, otherwise adhesion will be poor.
Once the glass is refitted, uniform and sustained pressure is needed for the adhesive to bond correctly around the entire perimeter, ensuring the housing's seal.
