Rear Telephoto Camera Adhesive Samsung Galaxy S26 Ultra (Service Pack)
This rear telephoto camera adhesive is designed for the Samsung Galaxy S26 Ultra. It is used to reattach the telephoto module against the rear glass when replacing the camera or the glass, for a clean and durable bond. This is an original manufacturer part, supplied as a Service Pack, in Samsung repair packaging. Fitting this adhesive is recommended for every intervention involving the rear camera, to prevent any play in the module or seepage under the glass. This part is covered by a 2-year warranty.
When should you replace the telephoto camera adhesive?
On the Galaxy S26 Ultra, the rear telephoto module is held in place by a dedicated adhesive. Over time, following an impact, a drop or a previous repair, this adhesive loses its holding power: the camera moves slightly in its housing, the rear block's water resistance is no longer ensured, and dust or moisture can get in around the lens.
This replacement almost always happens in the same context: during a rear camera or rear glass replacement, when the old adhesive has been removed and cannot be reused. An adhesive that has already been peeled off once no longer sticks properly a second time.
Rear Telephoto Camera Adhesive Galaxy S26 Ultra: Samsung Service Pack
The Quality line on this listing states Service Pack. This is not a refurbished part: it is a new part, delivered in the repair packaging used by the manufacturer for its authorized centers. Nothing has been salvaged or reassembled, unlike an Original part taken from a disassembled device.
For an adhesive, this point directly affects the result: an original adhesive retains its nominal holding power and its calibrated thickness, two factors that determine the water resistance of the camera block once refitted.
Compatible with which Galaxy S26 Ultra?
This adhesive is designed for the Samsung Galaxy S26 Ultra exclusively. The manufacturer reference associated with this part is GH81-28660A: it allows you to check, before ordering, that it matches the reference shown on the original adhesive or on the repair center's order form.
What the installation requires
The adhesive is applied in a single go: once positioned, it can no longer be cleanly removed to be readjusted. The camera module must be precisely aligned before application, otherwise the lens will be misaligned with the rear glass opening.
This operation generally takes place at the same time as the camera or rear glass replacement, never on its own on an otherwise intact device.
Warranty on this part
This part is covered by a 2-year warranty.
