Adhesive Double Sided Battery Samsung Galaxy S25 FE (Service Pack)
This double-sided battery adhesive is designed for the Samsung Galaxy S25 FE. It is an original manufacturer part, supplied in Service Pack: Samsung's official repair packaging, with no handling or refurbishment on this listing. It ensures battery attachment to the chassis during replacement, with the adhesive necessary for clean and durable installation. The manufacturer reference GH02-27481A guarantees a cut and adhesive identical to those factory-installed, for a replacement with no play or premature peeling. 2-year warranty.
Recognizing a battery to replace on the Galaxy S25 FE
A battery that drains in a few hours, a phone that shuts down without warning below twenty percent, or a case that bulges slightly on the back: these are the signs that precede a replacement. On the Samsung Galaxy S25 FE, the battery is held to the chassis by a double-sided adhesive that loses its sticking power with heat and repeated charge cycles.
Removing the old battery almost always tears this adhesive. Putting it back with improvised glue never holds as well, and this is precisely the part that is missing once the battery is removed: without it, the new battery floats in the casing.
A Samsung part, with no refurbishment step
This reference is an original manufacturer part, delivered in Service Pack: the repair packaging used by Samsung itself. Nothing has been re-glued or restored here, this adhesive comes from the same circuit as parts assembled in the factory, cut to the exact dimensions of the Galaxy S25 FE battery.
It is this precision of cutting that makes the difference with a generic adhesive bought by the meter: a strip too wide overhangs on the chassis, a strip too thin leaves a gap that the battery eventually exploits.
The reference GH02-27481A, to verify before ordering
On Samsung parts, the manufacturer reference remains the most reliable marker. This one bears the code GH02-27481A, specific to the Galaxy S25 FE. A repairer who has already opened the device can compare it directly to the label stuck on the old battery before confirming their order.
Installation that leaves no gap
The adhesive grips on contact: it does not forgive poor positioning, because peeling off an already-placed adhesive almost always damages it. It is applied to a clean and dry chassis, degreased if needed with isopropyl alcohol, before repositioning the battery on top. Pressing firmly over the entire surface, without bending the strip, prevents air pockets.
Once the battery is in place, it must hold on its own, without manual pressure: this is the sign that it is well bonded.
A replacement covered for two years
This part is guaranteed two years. A defect found after installation, within this period, is covered.
